Thermador MASTERPIECE WDC30J Manual De Instalación página 12

4. Secure with three (3) 3/4" (3.175 mm) Phillips head
screws (included).
20⅝"
(524 mm)
20⅝" (524 mm)
5. Insert plug into three-prong, grounded outlet (see
"Power Requirements and Grounding" on page 2 for
electrical specification).
English 10
=
=
Figure 8: Anti-tip Bracket Location
6. Slide warming drawer assembly into cutout until it is
flush with cabinet. Take care that the side screws of
the warming drawer do not scratch the cabinet.
7. Drill pilot holes through side flange holes with a 1/8"
(3.175 mm) wood bit.
8. Secure with four (4) stainless Phillips screws through
holes in front frame (Figure 9).
9. Turn power on at the service panel.
10. Turn the warming drawer on. Indicator light and timer
should turn on immediately. Close the drawer for
approximately 30 seconds then check for warmth.
Figure 9: Secure Warming Drawer