Menu Options - Promax OP-009-PS Manual De Instrucciones

3.2.2

Menu Options

After installing and connecting this module, user can use the analyser for
measurement of optical signals as if it were RF signals. Steps to measure a signal are
as follows:
1.- On the analyser, select the frequency band, terrestrial (for optical links) or
satellite (for optical LNB), by pressing the
two bands.
2.- Access the menu for measurement of optical fibres by pressing the EXTERNAL
UNITS POWER SUPPLY
3.- Select the OPTICAL LNB option and switch it to ON.
4.- Next the menu of the conversion module appears. Depending on whether is
terrestrial or satellite signal, the menu changes (see figure).
Figure 9.- Terrestrial Optical signal.
Figure 10.- Satellite Optical signal.
Page 12
User's Manual OP-009-PS
[14] key to switch between these
[11] key.
09-2012