Troubleshooting - Sunbeam GCSBNC-100 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IRONING TIPS CONT.
IRONING PANTS
Begin with the waistband and inseam area, then pockets and cuffs.
Pull waistband on pointy end of the board, as if you're "dressing" the ironing
board. Iron upper-front part of the pants, including the waistband.
Place pants parallel to ironing board lengthwise so both legs are facing the same
direction. Iron each leg by moving the iron back and forth along the pant leg.
Take cuff of the leg and bring it over towards the waistband to iron the inner part
of the leg. Repeat these 2 steps for the second leg.

TROUBLESHOOTING

PROBLEM
CAUSE/SOLUTION
Red Indicator Light is
• The light blinks to indicate that the iron auto-off
blinking
function has been activated.
• To stop the blinking and reset, move the iron back
and forth and allow to reheat.
Iron is not heating
• Check that unit is plugged into the Heating Base and
that the electrical cord is plugged into a working
electrical outlet.
• Adjust Fabric Select Dial to the correct setting for
your garment.
• Verify the auto-off function is not active. Refer to
MOTION SMART
section for details.
Iron will not steam
• Ensure water tank level is at least ¼ full.
• Ensure steam lever is set to a steam setting.
• Press SHOT OF STEAM
prime.
Iron is leaking
• Only fill with water to the Max level.
• SHOT OF STEAM
frequently. Only use in 3-second intervals or less.
• Empty de water reservoir after each use and move
Steam Lever to the Dry
3-WAY AUTO-OFF FEATURE
®
®
button several times to
button has been pressed too
®
setting.
-E14-
TROUBLESHOOTING
PROBLEM
CAUSE/SOLUTION
Iron leaves spots/
• Empty water reservoir completely after each use.
flakes on clothing
• Clean soleplate when cool with a wet, damp cloth.
• Use self-cleaning feature once a month.
• Refer to the Anti-Calcium System section.
• Ensure water cup used to fill the iron is clean.
Wrinkles are not sufficiently
• Use SHOT OF STEAM
removed
help remove stubborn wrinkles.
• Check that the Fabric Select Dial is set to the correct
fabric setting
• Refer to Ironing Tips or visit www.sunbeam.com for
more tips and hints.
Fabrics are getting an
• Use an ironing cloth or a 100% white cotton fabric
unwanted "shine"
and place it between the garment being ironed and
the iron to prevent "shine."
CONT.
or SPRAY MIST
features to
®
®
-E15-

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gcsbnc-101

Tabla de contenido