Before Starting The Equipment - ALPHA-TOOLS A-MF 1300 Manual De Instrucciones Original

Anleitung_A_MF_1300_SPK7:_
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Setting the groove depth (Fig. 1)
Slacken the locking screw (6).
Set the depth stop (7) to the desired depth.
Tighten the locking screw (6).
5.2 Fitting the vacuum extractor unit adapter
(Fig. 3/4)
Important! For health safety reasons it is imperative
that you use a vacuum extractor unit. The extractor
socket is suitable for use on vacuum extractor units
(vacuum cleaners). The extractor unit must be
suitable for the extraction of fine dust.
Slot the pins on the vacuum extractor unit adapter
(9) into the recesses on the extractor
connection (a).
Turn the adapter (9).
Unscrew the cap (b).
Insert the vacuum extractor unit hose well into the
opening on the adapter (9).
Tighten the cap (b) until the hose is held firmly in
place.
5.3 Trial run for new diamond cutting wheels
Have the equipment run in idle mode for at least 1
minute with the cutting wheels fitted. Replace
vibrating wheels immediately.
6. Operation
6.1 Switch (Fig. 5)
The equipment comes with a safety switch which is
designed to prevent accidents.
To start the equipment, push the locking lever (5)
forwards and then press the ON/OFF switch (4).
Wait until the machine has reached its top
speed.
27.01.2010 15:52 Uhr Seite 11
6.2 Changing and setting the diamond cutting
wheels (Fig. 6-11)
Important! Pull the mains power plug from the
socket-outlet.
Remove the handle (8).
Remove the screws (a) and the locking screw (6).
Take off the guard hood (3).
Swing the depth stop (7) down and away.
While holding the spindle lock (2) pressed,
unscrew the outer flange (b) with the supplied
flange nut wrench (c).
Remove the spacer rings (d).
Remove the inner flange (e).
Thoroughly clean the spacer rings, flanges and
fastening parts.
Fit the inner flange (e).
Then fit the diamond cutting wheels together with
the spacer rings (d) to achieve the desired groove
width.
Important! Take account of the direction of rotation
when fitting the diamond cutting wheels!
Important! Diamond cutting wheels must always be
replaced as pairs!
You have 6 spacer rings available, each one
being approx. 3.5mm in width. Please note that
the width of the groove is determined by the sum
of the spacer rings between the diamond cutting
wheels and the thickness of the cutting wheels.
All 6 spacer rings (d) have to be fitted irrespective
of the desired groove width.
Now re-assemble the device in reverse order,
taking care in so doing to ensure that all parts are
fitted correctly and tightly.
Important!
Only ever press the spindle lock when the motor
and grinding spindle are at a standstill!
You must keep the spindle lock pressed while
you change the wheel!
6.3 MOTOR
It is vital for the motor to be well ventilated during
operation. Be sure, therefore, to keep the ventilation
holes clean at all times.
6.4 Working with the masonry channel cutter
(Fig. 12)
Important! The device is fitted with an overload cut-
out. The motor will cut out if overloaded. Relieve the
load on the motor immediately and allow the
masonry channel cutter to cool down for approx. 1
minute without load.
GB
11