Display - Kenmore 580.75051 Manual Del Propietário

Acondicionador de aire de ventana
Ocultar thumbs Ver también para 580.75051:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DISPLAY
REMOTE CONTROL SIGNAL RECEIVER
TEMPERATURE SETTING
• Use this button to automaticallycontrol the temperature
of the room. The temperature
can be set within a range of
60°F to 86°F by increments
of I°F.
I
_
ENERGY SAVER
V
TEMP
A
_
[
[
. The fan stops when the compressorstops cooling.
J
Approximately
every 3 minutes
the fan will turn on and
check the room air to determine
if cooling is needed.
ENERGY
o
SAVER
[
MODE
FAN 0
COOL O
TIMER
ON/OFF
FAN
SPEED
H I/LO
_- DISPLAY COOL/FAN
I
|. Everytimeyou push this button, it will toggle between
COOL and FAN.
|.
You will usually use shut-off time while you sleep.
|.
If unit is running, Timer sets number of hours until shut-off.
• For your seep ng comfort, once T mer s set, the Temperature
O
i
setting will raise 2°F after 30 min., and once again after another
30 min.
• Every time you push Timer button, it advances the Timer setting
as follows: ! Hour ) 2 Hours ) etc. !_ 12 Hours maximum.
START TIME
• If unit is off, Timer sets number of hours before unit starts.
• Every time you push Timer button, it advances the Timer setting
as folIows: 1 Hour Ip 2 Hours Ip etc. _. 12 Hours maximum.
POWER
• To turn the air conditioner ON, push the button.To turn the air
conditioner
OFF, push the button again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cool mode, High fan
speed, Temperature
setting at 72°F.
FAN SPEED
• Everytimeyou push this button,it advancesthe setting as
follows:
{High(F2)
_. Low(F1)
_, High(F2)}
In failure of electric power, the unit runs as previous setting operation.
-10-

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido