Remote Control - Kenmore 580.75051 Manual Del Propietário

REMOTE CONTROL
Note: The Remote Controller will not operate properly if strong light shines on the sensor window of the Air
Conditioner or if there are obstacles between the Remote Control and the Air Conditioner.
Every time you push button, you will hear a beep from the Air Conditioner.
POWER
• To turn the air conditioner ON, push the button. To turn the air
conditioner OFF, push the button again.
• This button takes priority over any other buttons.
• When you first turn it on, the unit is in cool mode, High fan speed,
Temperature setting at 72°F.
TEMPERATURE SETTING
• This button can automatically control the temperature
of the room. The temperature can be set within a range of
60°F to 86°F by increments of I°F.
FAN SPEED
• Everytime you push this button it advances the setting as
follows: {(High(F2) _, Low(F1) _ High(F2)}
ON/OFF TIMER
SHUT-OFFTIME
• You will usually useshut-off time while you sleep.
• If unit is running, Timer sets numberof hours until shut-off.
• For yoursleepingcomfort,once Timer is set, the Temperaturesetting
will raise2°F after 30 min., and once again after another30 min.
• Every time you pushTimer button,it advancesthe Timer setting as
follows: 1 Hour _,2 Hours _,etc. _.12 Hours maximum.
START TIME
• If unit is off, Timer sets numberof hours beforeunit starts.
• Everytime you pushTimer button,it advancesthe Timer setting as
follows: 1 Hour _ 2 Hours _ etc. _ 12 Hours maximum.
FAN SPEED
L I TIMER
MODE
ENERGY
SAVER
ENERGY SAVER
The fan stops when the compressor stops cooling.
• Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
COOL/FAN
• Everytime you push this button, it will toggle between
COOL and FAN.
-11 -