Publicidad
Idiomas disponibles
Idiomas disponibles
Carry out the electrical connection, by using the
appropriate power cord.
Sucking version
Fix the pipe bearing bracket to the wall and/or
ceiling by using the anchor screws and screws
provided (fig. 8), centred to the hood.
Connect the motor air-outlet flange to the exhaust
hole, by using a suitable pipe.
Place the two ornamental pipes on the hood
body; lift the internal pipe up until it reaches the
ceiling; then fix it to the pipe bearing bracket, by
using the two self-threaded screws provided.
Filtering version
In case that the appliance is used in the filtering
version mode, it is necessary to install the char-
coal filters. First remove the metal grease-filter,
as indicated for each model in the MAINTENAN-
CE part, then place the charcoal filter in his seat
just behind the grease-filter.
WORKING
(fig. 9)
A : ON/OFF lights
B : speed reduction / OFF motor
C : speed indicators
D : ON motor/speed increase
E : 10 min timer.
The Touch control panel on the glass allows you
to set the function desired by lightly touching the
corresponding key.
If the electrical power supply to the model is cut,
15 seconds are needed for self-diagnostic after its
functions are restored. In the meanwhile, its ope-
ration may be incorrect.
All of the appliances are equipped with an elec-
tronic device allowing for automatic switching off
after four hour working from the last operation
performed.
13
Publicidad
