General indications
Press General indication button (V) to switch the
following display indications:
- For RideControl EVO:
∙
Trip time, distance, average speed, top
speed, ODO (total distance), remaining range,
cadence.
The display will start up in the position it was
switched off.
In case the power assist mode is in 'OFF', the
remaining range will show '999'.
- For RideControl CHARGE:
∙
Speed <-> average speed
∙
Trip distance / ODO (total distance)
- For RideControl ONE:
∙
RideControl ONE can send ride data via the
ANT+ protocol*. An ANT+ capable device,
like some smartphones or GPS devices, can
display certain ride data when paired with
RideControl One, such as:
∙
Speed, cadence, power, battery level and
more**
* Available only on RideControl ONE with
ANT+ logo.
** Available data fields can be subject to
change due to hardware or firmware updates.
** Which of the available data fields will be
displayed depends on the receiving device.
3.4.3 Reset settings
Press both Assistance buttons 'up' and 'down'
(R) simultaneously for THREE seconds to reset
trip distance, trip time and average speed.
This reset can only be done when one of these
settings is shown on the display.
18