Steren K-800 Manual De Instrucciones página 2

Before using your new Electronic Snap Circuits, please read this Before using your new Electronic Snap Circuits, please read this
instruction manual to prevent any damage. Put it away in a safe instruction manual to prevent any damage. Put it away in a safe
place for future references. place for future references.
DO's AND DON'Ts OF BUILDING CIRCUITS
After building the circuits given in this booklet, you may wish to
experiment on your own. Use the projects in this booklet as a guide, as
many important design concepts are introduced throughout them. Every
circuit will include a power source (the batteries), a resistance
(which might be a resistor, lamp, motor, integrate circuit, etc.), and
wiring paths between them and back. You must be careful not to create
"short circuits" as this will damage components and / or quickly drain
the batteries. Only connect the ICs using confi gurations given in the
projects, incorrectly doing so may damage them.
Steren is not responsible for parts damaged due to incorrect wiring.
• Always use eye protection when experimenting on your own.
• Always include at least one component that will limit the current
through a circuit, such as the speaker, lamp, capacitors, motor,
microphone, etc.
• Always disconnect the batteries immediately and check your wiring
if something appears to be getting hot.
• Always check your wiring before turning on a circuit.
• Never leave a circuit unattended when it is turned on.
• Never touch the motor when it is spinning at high speed.
ENGLISH-02