Publicidad
Enlaces rápidos
Publicidad
Manuales relacionados para Atlantic Herrin 38408116
Resumen de contenidos para Atlantic Herrin 38408116
- Página 1 Herrin Locking Bar Cabinet Customer Service: 800-747-2660 Item # 38408116 Ver. 01 6/28/19...
- Página 2 Tools Needed (Not Included) Haramientas requeridas/ no incluidas Phillips screwdriver Stud Finder Pencil Power drill Destornillador Phillips Detector de Vigas Lápiz Taladro eléctrico...
- Página 3 Attach 12 cam screws (AA) to panels A, B and C with a screw- Press 8 wood dowels (CC) into holes adjacent to the 8 cam driver. screws in panels B and C. Slide panels D and E over dowels and cam screws on panel B.
- Página 4 Press 4 wood dowels (CC) into holes adjacent to the 4 cam Attach 4 cam screws (AA) to panel G with a screwdriver. Attach screws in panel A. Slide panel A into panels B and C. Insert 4 drawer sides H and K to drawer back J with 4 screws (EE). cam locks (BB) and lock each with screwdriver turning clock- Fije 4 tornillos de leva (AA) al panel G con un destornillador.
- Página 5 Slide drawer bottom (L) into drawer slots until it is flush with To install drawer, pull out both outer slides. Pull out both inner drawer sides. Slide drawer front (G) with 4 cam screws into slides with your finger. Align both drawer tracks with the slides. drawer sides until flush with drawer sides.
- Página 6 Attach back panel (M) with 24 screws (GG) using a Insert four shelf brackets (HH) in the pre-drilled holes as screwdriver. shown. Slide adjustable shelf (N) into place and check that it is level. Slide the two wine rack panels (P) together. Then push Fije el panel trasero (M) con 24 tornillos (GG) con un the assembled wine rack into the lower cabinet section.
- Página 7 Attach three hinge assemblies (KK) to the back of door panel Attach door pull and screw (LL) to the front of door panel (Q) (Q) with two screws (JJ) each using a screwdriver. using a screwdriver. Slide three door panel hinge assemblies into hinge brackets.
- Página 8 Secure the bar cabinet to the wall by placing one mounting bracket (MM) at the desired position on the wall using a stud finder to secure to a stud. Mark the hole position on the wall with a pencil. Drill a hole and insert the plastic anchor into the wall.
-
Página 9: Product Warranty
NO lo devuelva a la tienda. Por favor póngase en contacto con el servicio al cliente al (800) 747-2660 de unes a jueves, de 8am a 5pm; viernes, de 8am a 12pm (Hora del Pacifico). Por favor guarde este Manual de Instrucciones para futura referencia. ©2019 Atlantic Inc. Santa Fe Springs, CA. U.S.A Made in China Hecho en China All rights reserved www.atlantic-inc.com...