Shure AD610 SHOWLINK Guia Del Usuario página 10

Setting Power Levels
Adjust the access point's power level using Wireless Workbench.
1. Open the Properties panel for the access point in Wireless Workbench.
2. Select a power setting and apply changes.
Specifications
Antenna Type
2 Omnidirectional 2.4 GHz
Capacity
16 Axient ShowLink Transmitters, including both analog and digital models
Mounting Type
WA371 Mic Clip, 1/4-20 thread mount, or M6 x 1.0 thread mount
Operating Temperature Range
-18°C (0°F) to 63°C (145°F)
Storage Temperature Range
-29°C (-20°F) to 74°C (165°F)
Dimensions
190 mm x 102 mm x 47 mm (7.48 in. x 4 in. x 1.85 in.) H x W x D, without antennas
Weight
464 g (16.3 oz.), without antennas
Housing
Extruded Aluminum
Power Requirements
Power over Ethernet (PoE) Class 1
External Power Supply (if PoE is
unavailable)
ShowLink
Network Type
IEEE 802.15.4
Frequency Range
2.40 to 2.4835 GHz (16 channels)
RF Output Power
10 dBm ERP / 20 dBm ERP (dependent on applicable country regulations)
Working Range
Under typical conditions
Line of Sight, outdoors for a single system
Note: Actual range depends on RF signal absorption, reflection and interference.
Antenna Connection
Connectors
2 SMA (Shell=Ground, Center=Signal)
Impedance
50 Ω
Scanning Radio
Scanner RF Sensitivity
-106 dBm, typical (integrated antenna)
Networking
Network Interface
Ethernet 10/100 Mbps
Network Addressing Capability
DHCP or Manual IP address (configurable using Wireless Workbench)
36 to 57 V DC/V AC
15 V DC (600 mA), double insulated
150 m (500 ft)
500 m (1600 ft)
10