Included Components; Optional Accessories - Shure AD610 SHOWLINK Guia Del Usuario

AD610 ShowLink Access Point
The AD610 ShowLink™ access point enables real-time remote control of all ShowLink-enabled Axient™ transmitters, including both digital and analog
models. The access point allows comprehensive management of transmitter parameters from the receiver or Wireless Workbench
wireless network communication. All parameter changes occur without interruption to the performer.
Multiple access points can extend the operational range or increase the number of transmitters supported on the ShowLink network. The access point
features true diversity antenna inputs along with mounting points for ¼"-20 and M6 x 1.0 thread.
ShowLink Access Point Overview
Features
• Real-time wireless remote control of up to 16 transmitters per ShowLink
access point
• New RF design and true diversity antenna scheme for improved link
performance
• Easy transmitter authentication—Recognizes linked transmitters upon
IR sync
• Provides coverage area approximately the same as the transmitter's
range
• Automatic hand-offs between multiple access points extend operating
range
• Automated channel selection—Independently scans 2.4 GHz frequency
range and determines best channel for use
• Automatic frequency agility—Moves a ShowLink network to the best
available 2.4 GHz channel in the event of signal degradation
• Wireless Workbench 6 software supports networked control of all de-
vice functions and provides a ShowLink plot for viewing 2.4 GHz signal
levels
• Receives power via Power over Ethernet (PoE) network connection or
from an external power supply
• Versatile mounting options—Fits microphone stand adapters and has
built-in ¼"-20 and M6 x 1.0 threading for permanent installation
• Backwards compatible with Axient analog transmitters and receiver
① ShowLink 2.4 GHz detachable antennas
② ShowLink Data Status LED (blue)
③ Power Status LED (green/amber/red)
PUSH
④ Ethernet Status LED (green)
⑤ ¼"-20 threaded mounting point
⑥ External power supply connector
⑦ Reset button
⑧ Ethernet port
⑨ Scanning antenna for channel agility
⑩ M6 x 1.0 threaded mounting point

Included Components

Wireless microphone clip for mounting on a microphone
stand
Euro thread adapter for WA371
Shielded 25-foot Ethernet cable for ShowLink access
point, RJ45-to-EtherCon connector
Power supply (regionally dependent)

Optional Accessories

Directional 2.4 GHz patch antenna
7
For 2.4 GHz signals
- ON Steady: Linked, no data transmission
- Flashing: Transmitting data. Rate of flashing indicates level of activity
- Steady Green: Power ON, power source = PoE
- Steady Amber: Power ON, power source = external power supply
- Red Flashing: Response to remote ID flash command
- ON Steady: Ethernet connected, no traffic
- ON Flashing: Ethernet connected, flashing corresponds to volume of data
traffic
Use to wall-mount the access point
Connection point for external power supply
Press to restore factory settings
For network connection and Class 1 PoE
Scans the 2.4 GHz spectrum for the best frequency
Use to mount access point to safety cable
6 using 2.4 GHz
®
WA371
31A1856
95A15104
PS43
AXT644 (available
depending on regional
regulations)