Safety information
This appliance is intended for
domestic use or for house-
hold-based, non-commercial
applications. Household-based
applications include, e.g. us-
age in employees catering
facilities for shops, offices, ag-
ricultural and other commercial
operations, as well as usage by
guests of guest houses, small
hotels and similar residential
establishments.
Install and operate the appli-
ance as described in the text
and illustrations. We do not ac-
cept liability for damage result-
ing from failure to heed these
instructions.
This appliance is intended
for use up to an altitude of
2000 m above sea level.
The appliance may only be
installed and stored in a frost-
free room (due to residual
water).
Risk of electric shock!
Switch off the mains volt-
age supply immediately if
a fault occurs (DH05101,
DH06101, DH06111) or
disconnect the mains plug
(DH04101).
Immediately shut off the
cold water supply to the
appliance should it leak.
10
en
The continuous-flow heater
may only be connected and
put into operation by a quali-
fied professional.
In order to avoid potential
sources of danger, repairs
and maintenance may only
be undertaken by a suitably
qualified specialist.
Never open the appliance
without disconnecting the
power supply beforehand.
The statutory regulations of
the respective country, as well
as those of the local electricity
and water suppliers, must be
adhered to.
IEC 600364-7-701
(DIN VDE 0100, part 701)
must be observed when in-
stalling the appliance and/or
electrical accessories.
The continuous-flow heater is
a Class I appliance and must
be connected to the protective
earth.
The appliance must be per-
manently connected to in-
stalled pipes. The conductor
cross-section must comply
with the installed appliance
power.
Caution: Earthed water pipes
may give the appearance of a
connected protective earth.