Installation Instructions; Product Description; Preparation For Installation - Siemens DH04101 Instrucciones De Instalacion Y De Uso

Congratulations on purchasing this Siemens ap-
pliance. You have acquired a top-quality product,
which will give you a lot of enjoyment.
Please read this installation and operating in-
struction manual carefully, then act accordingly!
Store for future reference.

Product description

This instruction manual describes various appliance
models.
Only for permanently connected appliances: The
appliance complies with IEC 61000-3-12.
The hydraulically controlled flow-through water
heater is suitable for either an open (depressur-
ised) or closed (pressurised) connection.
The flow-through water heater continuously
heats water while it flows through the appliance.
The appliance must not be operated with pre-
heated water, otherwise the overtemperature
protection will be triggered.
DH04101: This appliance is connected to the
mains by a plug.
DH05101, DH06101, DH06111: These appli-
ances are designed for permanent electrical
connection.
DH06111 High level appliance
DH04101
DH05101 Under counter appliances
DH06101
12
en

Installation instructions

Install the continuous-flow heater as described in
the illustrated section. Observe the instructions
in the text.
The illustrations can be found in the centre of the
instruction manual.
Installation
I.
Unpacking/scope of supply
Unpack the appliance and check for transport
damage.
Dispose of the packaging and, where applicable,
the old appliance, in an environmentally con-
scious manner.
1 Housing
2 Mounting (2 screws, 2 wall plugs)
3 ON indicator (only on the DH06111)
4 Filter and sleeve (inserted in inlet)
5 Jet regulator and seal
6 Only for appliances with a permanent electrical
connection: Rubber grommet

Preparation for installation

Important: Only use the enclosed installation set.
Shut off water supply. The electrical connection
(connection cable) must be disconnected from
the power supply. Unscrew the fuse or switch off
the circuit breaker.
There must be a clearance of approximately
60mm on all sides of the appliance for
installation
Observe the thechnical data for the appliance.
DH05101, DH06101, DH06111: Unscrew the
screws on the housing cover and remove the lid.