Troubleshooting Guide - Mason & Deck ME2MOGO Manual Del Propietário

SAFETY & MAINTENANCE GUIDE (CONTINUED)

TROUBLESHOOTING GUIDE

Customer Service Center Contact: See last page of User Manual.
PROBLEM POSSIBLE CAUSE
Cord is not plugged in.
No discharge of
air.
Power is not ON.
Pump is not turned ON.
Air is too humid.
Not Cooling.
Room Conditions.
Not enough Cross
Ventilation.
Unit is making Unit is loud or making too
noise. much noise
In cooling mode, the Air
Excessive
Cooler produces moisture
humidity when
as a result of evaporative
used indoors.
cooling. This is normal.
SOLUTION
Make sure power cord is plugged in and the switch is
ON.
Turn the unit ON by pressing the power button on the
control panel / remote control or turn the SPEED knob.
For evaporative cooling to start, turn on COOL function
from remote on control panel.
Evaporative cooling creates moisture & the cooling
effect is best in humidity of 60% or lower.
Environmental factors can affect the cooling effect such
as too much direct sunlight entering the room, too many
people inside the room, too much humidity.
Windows and/or a door should be kept open to allow for
adequate cross ventilation.
It is normal for noise to be produced as this evaporative
air cooler creates powerful wind with large fan blades
and/or powerful blower. Reduce the fan speed for lower
noise levels if needed.
The Air Cooler cools best in dry climates. If the ambient
humidity level is high (approx. 60% or above), refrain
from using the Air Cooler until ambient humidity is
reduced.
Make sure the window/doors are open and there is
adequate cross-ventilation in the room so that the
moisturized air can circulate better. Do not use the
evaporative cooling function on days with high ambient
humidity.
6 EN