A-B. Mark the position of hole of the sliding door guide (Q). Drill a pilot hole for the sliding door guide (Q) using a ø3 mm (1/8 in) drill bit.
C. Install the sliding door guide (Q) with the screw (DD) and the cap (II).
D. Place the support bar anchor (G) back on its wall mark, then mark its center on the wall.
E-F. Drill a hole on the center marks with a ø8 mm (5/16 in) drill bit . If there are no studs located behind the support bar anchor (G), then insert the wall anchors
(AA) using a rubber mallet until the wall anchors are flush with the wall. Fix the center fitting on the support bar anchor (G) using the screws (CC).
A
Q
C
II
DD
E
ø 8mm
5/16 in
FIXED PANEL AND SUPPORT BAR INSTALLATION
Q
Add a drop of silicone in the holes
before inserting the screws.
If there are no studs aligned to the wall track behind the
drywall, use the wall anchors to ensure the screws won't