Premises And Safety Notes; Application Range; Safety Standards - Aprimatic UNICO RR-SE Manual De Instrucciones

GB

1. PREMISES AND SAFETY NOTES

1.1 Aplication range
Snap on radio receiver module for controlling an Aprimatic control
unit and a maximum of another 3 generic devices (with dedica-
ted optional relay modules). May only be used in combination
with Aprimatic control units and remote controls.
When controlling the various devices of the Aprimatic units, follow
the capacity limits for the contacts indicated in the technical
specifi cations.
This product can be used in the whole European commu-
nity freely.

1.2 Safety standards

• Carry out the operations as specifi ed by the Manufacturer.
• The installer must check the correct installation and functio-
ning of the equipment.
• Do NOT use the product for purposes other than those envi-
saged or use it improperly.
• Do NOT tamper with or modify the product.
• Only use equipment which is in a good state.
• Do NOT work in areas which are not well-lit or in areas which
provide a risk for the health.
• Do NOT allow people to pass through the work area.
• Do NOT leave the work area unmanned.
• Always disconnect the mains power supply before opening
the container.
• The product must only be installed by qualifi ed technical
personnel.
The electrical system must comply with the standards appli-
cable in the country in which it is installed.
IMPORTANT before to power on the control
!
unit, carry out the follow operations:
Rotate the wire antenna about 90° as shown in the picture.
Removing provisionally the radio receiver UNICO from
the control unit could be necessary in order to allows the
antenna positioning.
IMPORTANT: the control unit can be powered only when the
antenna of the receiver is correctly positionned.
INSTRUCTIONS
d
SNAPPING ON TO THE CON
TROL UNIT RADIO CONNECTOR
11
c
ROTATE THE WIRE
ANTENNA ABOUT
90°
-