Bosch 4405 Instrucciones De Funcionamiento Y Seguridad página 15

Adjustments
Blade 33.9 ° To Table
33.9 ° Blade Alignment Check
NOTE: You must check and align 45° and 90° set-
tings first before doing 33.9° (See pages 13 and 14).
1. Rotate table to 0 ° position and lock in place.
2. Make sure head assembly is pushed back
fully against stop and slide rail lock knob
is tightened.
3. Lower head assembly. Lock in place.
4. Make sure the 33.9 ° bevel stop screw jam
nut is in the active position, in-line with the
90 ° and 45 ° bevel stop screw jam nuts.
.
Loosen bevel lock handle and tilt the head
assembly to 33.9 ° bevel. Check the 33.9 °
bevel stop. The bevel indicator should be on
the 33.9 ° mark.
6. If the blade is not 33.9 ° with the table, adjust
33.9°bevel stop.
33.9 ° Blade Alignment Adjustment
1. Lower the 33.9 ° bevel stop screw jam nut
using 12mm or adjustable wrench (Figure 12).
2. Loosen bevel lock handle.
3. Lower the saw onto the 33.9 ° stop.
4. Adjust the 33.9 ° bevel stop until bevel indica-
tor is pointing to the 33.9 ° mark on the bevel
scale (see Figure 12). Tighten 33.9 ° jam nut.
Figure 11. Blade 33.9 ° To The Table
45°/33.9
Stop
33.9 ° Stop
Screw
Jam
ll,I iI %
Figure 12. Bevel 33.9 ° Stop Screw and Jam Nut
15.