Leveling The Dryer; Reversing The Door Swing - KENMORE ELITE 796.8178 Manual De Uso Y Cuidado

LEVELING THE DRYER

WARNING:
• Wear gloves during installation.
• Failure to follow these instructions can result in injury.
To ensure that the dryer provides optimal drying
performance, it must be level. To minimize vibration,
noise, and unwanted movement, the fl oor must be a
level, solid surface.
NOTE: Adjust the leveling feet only as far as necessary
to level the dryer. Extending the leveling feet more than
necessary can cause the dryer to vibrate.
Position the dryer in the fi nal location. Place a level
1
across the top of the dryer.
All four leveling feet must rest solidly on the fl oor.
Gently push on the top corners of the dryer to make
sure that the dryer does not rock from corner to corner.
Use a wrench to turn the leveling feet. Turn the
2
leveling foot clockwise to raise the dryer; turn the
foot counterclockwise to lower the dryer. Using a
level, adjust the feet until the dryer is level from side
to side and front to back. Make sure all four feet
are in fi rm contact with the fl oor.
NOTE: If you are installing the dryer on the optional
pedestal, the dryer leveling feet should be fully retracted.
Use the leveling feet on the pedestal to level the dryer.
The swing of the dryer door can be reversed to fi t your
installation location.
THE DRYER DOOR IS VERY LARGE AND HEAVY.
Failure to follow the instructions below can result in
damage to the dryer, property damage or personal injury.
• To avoid damage to the dryer or the door, support the
door with a stool or box that fi ts under the door, or
have an assistant support the weight of the door.
• Always reverse the door BEFORE stacking the dryer on
top of the washer
• Avoid dropping the door to avoid damage to the door
Level
or the fl oor.
Hole Cap
Leveling Feet
Open the dryer door.
1
2 Using a Phillips screwdriver, remove the two latch
screws and the latch.
Remove the two hole caps, one each above and
3
below the latch by rotating them slightly clockwise.
While supporting the weight of the door, remove the
4
four hinge screws.
CAUTION: Be sure to support the weight of the door
before removing the hinge screws.
Carefully turn the door upside down and reinstall it on
5
the opposite side using the screws removed in step 4.
Install the door latch in the opening on the side from
6
which the door was removed using the screws from
step 2.
Install the hole caps removed in step 3 in the holes
7
above and below the latch where the door was
originally mounted.
Test the door for proper operation and make sure it
8
latches properly.
17
INSTALLATION INSTRUCTIONS

REVERSING THE DOOR SWING

WARNING:
Remove
Door
Latch
Latch
Screws
Hinge Screws
Hinge
Screws
Insert Hole
Cap
Latch Screws