After Use - Rowenta A12HH9CUA Instructivo De Operación

TIP Always spray starch onto the reverse side of the fabric to be ironed.
4 • Dry ironing
Set the variable steam control to
material (care points •, ••, •••).
5 • Steam ironing
You can steam iron from temperature setting •• upwards.
Steam function : The steam quantity can be set to between no steam (minimum steam
quantity) and
We recommend setting to maximum steam quantity
temperature setting •••.
6 • Burst of steam
(from temperature setting •• upwards)
Press the burst of steam button
Wait a few seconds between each burst before pressing the button again.
7 • Vertical burst of steam
(from temperature setting •• upwards)
TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning
delicate fabrics.
Hold the iron to the vertical and press the burst of steam button (
creases from suits, jackets, skirts, hanging curtains etc.
IMPORTANT Never direct the steam at persons or animals!
8 • Spray
Press the spray button
9 • Anti-Drip system
This prevents water escaping from the soleplate when the temperature is too low.
10 • Automatic electronic 3-position Auto-Off*
If, although switched on, the appliance is not moved, it will automatically switch off and
the auto off light will blink after the following intervals:
- After 30 sec., if the iron is left resting on the the soleplate or lying on its side.
- After 8 mins., if the iron is left resting on its heel.
To switch the iron back on, move the iron gently.

AFTER USE

11 • Emptying
Unplug the iron (fig.4), pour away remaining water (fig.16) and set steam control to
Open and close the steam control several times (fig.17) to prevent the valve hole into the
steam chamber from scaling or blocking up.
12 • Storing
Allow the appliance to cool down before storing the iron standing on its heel (fig.23).
IMPORTANT Do not wind the cord around the hot soleplate. Never store your iron
placed down on the soleplate.
* depending on model
(maximum steam quantity) (fig.12).
to generate a powerful jet of steam (fig.13).
to dampen stubborn creases (fig.15).
(fig.11) and set the temperature to suit the type of
8
only when the iron is at
fig.14) to remove
.