Preparing For Use; Using The Appliance - Imusa Easy Fry classic Manual De Instrucciones

PREPARING FOR USE

1. Place the appliance on a flat, stable, heat-resistant work surface away from water splashes.
2. Do not fill the bowl with oil or any other liquid.
Do not put anything on top of the appliance. This disrupts the airflow and affects the
hot air frying result.

USING THE APPLIANCE

Easy Fry can cook a large range of recipes. Cooking times for the main foods are given in the
section 'Cooking Guide' .
1. Connect the power supply cord to an electrical socket.
2. Carefully pull the bowl out of the Easy Fry.
3. Place the food in the bowl.
Note: Never fill the bowl beyond the MAX level mark or exceed the maximum amount
indicated in the table (see into section 'Cooking Guide'), as this could affect the
quality of the end result.
4. Slide the bowl back into the Easy Fry.
Caution: Do not touch the bowl during use and for some time after use, as it gets very
hot. Only hold the bowl by the handle.
5. Move the temperature control knob to the required temperature. See section 'Cooking Guide'
to select the right temperature
6. Select the required cooking time (see section 'Cooking Guide').
7. To switch on the appliance, turn the timer knob to the required cooking time.
Add 3 minutes to the cooking time stated in the tables on pages 7 and 8 when using
the appliance from cold.
To set a short time, turn the timer knob until 10 minutes and then go back to the
desired time.
Note: If you want, you can also let the appliance preheat without any food inside. In
this case, turn the timer knob to more than 3 minutes and wait until the heating-up
light goes out (after approx. 3 minutes). Then fill the bowl and turn the timer knob to
the required cooking time (see Cooking Guide for timings).
• The timer starts counting down the set cooking time.
• The pre-heating light will illuminate.
• During the hot air frying process, the pre-heating light goes on and off from time to time.
This indicates that the heating element is switched on and off to thermostatically maintain
the set temperature.
8. Excess oil from the food is collected in the bottom of the bowl.
9. Some foods require shaking halfway through the cooking time (see section 'Cooking Guide').
To shake the food, pull the bowl out of the appliance by the handle and shake it. Then slide
the bowl back into the Easy Fry.
Tip: You can set the timer to half of the cooking time, and when the timer sounds shake the
ingredients. Then set the timer again for the remaining cooking time.
10. When you hear the timer sound, the cooking time set has finished. Pull the bowl out of
the appliance and place it on a heat-resistant surface.
Note: You can also switch off the appliance manually. To do this, turn the timer control
knob to 0.
8