Instructions For Assembly And Use; Installing The Safety Seat; Fastening The Child Into The Safety Seat - Be Cool FLOW ISO-FIX Manual Del Usario

EN
NEVER UNDER ANY CIRCUMSTANCE should you
carry your baby in your arms in the car, or out of
the car seat. Although it may seem strange, in case
of an accident, even at only 40 km/hr the force is
such that it would be completely impossible to hold
onto your baby.

INSTRUCTIONS FOR ASSEMBLY AND USE

1. INSTALLING THE SAFETY SEAT

INSTALLATION from 9 kg up to 18 kg (76-105cm):
1a Slide the lsofix anchors B (5) to their maximum length by
turning the lever A (17). Do this on both sides of the seat.
Open the cover (16) and take the top tether connector out (4).
1b Connect the lsofix anchors until you hear them click into place.
The display window on the button (15) will turn from red to green.
Push the seat as far back as possible. Make sure that both lsofix
are in the same position once you have pushed the seat back.
1c Connect the Top Tether in the anchor point intended for this in
the vehicle marked with the symbol:
Lastly, tighten the strap of the TT system until the green signal is
displayed on the indicator. The strap should go over the backrest
of the vehicle seat. If necessary raise the headrest or remove it.
The connector may be closed without being secured in the ISOFIX
anchor. Please make sure that the connectors are correctly
fastened into the anchor points of the vehicle by pulling the seat
18
once it has been installed.
To detach the seat follow the same steps in reverse: Move the
button (15) to open the connector and release the anchors.
INSTALLATION from 15 kg up to 36 kg (105-135cm):
Follow the same steps as before. In this case you should not
connect the Top Tether.
There is also the possibility of installing the seat only with the car
seat belt.

2. FASTENING THE CHILD INTO THE SAFETY SEAT

FLOW seat may be used for the following weight ranges:
9-18 kg using safety harness
15-36 kg the safety harness must be stored away and the child
should be secured with the vehicle seat belt.
SAFETY HARNESS 9KG-18KG
2a. Loosen the harness by pressing the button(10) and pulling
the diagonal part of the harness straps. Unfasten the buckle by
pressing the red button. Move the ends of the buckle to each side
of the seat so you can put the child in the seat. Position the child
in the seat and put the strap over him on the both sides, and then
fasten the buckle.
2b Tighten harness by pulling the lower strap A (11).
To get the child out of the seat follow the same process in reverse.
2a
STORING THE SAFETY AWAY:
Once the child reached a weight of 18 kg (105 cm tall approx) the
harness should be stored away and the child should be secured
with the vehicle safety belt.
2c To store the harness away it needs to be fully loosen f irst, lift
the cover under the cushion and store the buckle parts in the
compartment.Then put the cover back on the seat.