Opening The Box; Contents Of The Box; Installation Procedure - Urmet 1092/605 Guía Rápida

4

OPENING THE BOX

Check that the packing and the contents are not visibly damaged. Contact the retailer immediately if parts are either
missing or damaged. Do not attempt to use the device in this case. Send the product back in its original packing if it is
damaged.
4.1

CONTENTS OF THE BOX

N°1 Easy Dome 10X with IR LED
N° 1 Power supply
N° 1 Wall bracket
N°1 User manual
IMPORTANT NOTE
Accessories may be changed without prior notice.
5

INSTALLATION PROCEDURE

This section contain detailed instructions for installing Urmet Domus 1092/605. These instructions assume that the
installer has a good knowledge of installation techniques and is capable of adopting safe installation methods.
5.1 EASY DOME MINIMUM CONFIGURATION
The Easy Dome camera contains a built-in receiver that decodes the controls from the control keypad. At least one
keypad is therefore needed to control the camera. In addition to configuring operating parameters, the keypad is used to
manage horizontal axis (360° continuous) and vertical axis (180°) panning and tilting, motorised zooming, recalling and
programming the Easy Dome preset sequences.
The following sections show how to use these adapters.
Please check a 120 Ω resistor is mounted on both RS-485 terminals.
LBT 20137A 14