Bissell PET HAIR ERASER 1650 Serie Guia Del Usuario página 11

LED Lighted Crevice Tool
1
Pull tabs out of battery door
area before use to activate.
Connect to handle, wand or
hose and the LED Light will
automatically come on.
NOTE: When the small tab on the connection point of Crevice tool comes into contact
with the handle, wand, or hose; that triggers the LED light to come on. When using
with the Wand, be sure it does not pop through the opening at the end of the Wand.
Vacuum Motor Protection
An internal thermal protector has been designed into your vacuum to protect it from
overheating. When the thermal protector activates, the main vacuum motor will stop
operating. If this happens, proceed as follows.
1
Turn vacuum OFF and unplug from electrical outlet.
Check for the source of overheating problem (full
2
dirt cup, dirty filters or, a clog) and fix by following
the maintenance instructions.
3
When the motor cools for approximately
30 minutes, the thermal protector automatically
resets and cleaning may continue. If the vacuum
will not turn on or the thermal protector continues
to activate, your vacuum may need servicing.
Call BISSELL Consumer Care.
NOTE:
The thermal protector controls the main vacuum
motor only, not the brush motor. If the thermal protector
activates, the brush will continue to operate normally;
however, there will be no suction.
2
To replace LED battery, unscrew the small screw with
a Phillips head screw driver. Pull cover off to reveal
two batteries (CR1632 3V). Slide and pull out each
battery and replace with new. Be sure the "+" sign on
battery is facing out.
Dispose of used battery promptly. Keep away from
children. Do not disassemble and do not dispose of
in fire.
Filter
Filter
Possible areas that could clog.
www.BISSELL.com
11