Maintenance - Omcan IC-CN-0040 Manual De Instrucciones

BIN CONTROL OPERATION
The bin control is used to shut the machine off when the bin fills with ice. The bin control must be checked
upon installation or initial startup and
when performing maintenance. There
is one bin switch for each evaporator.
The actuator arm of the bin switch
comes in contact with the splash
curtain. When the bin is full of ice,
the splash curtain is held open when
ice drops off of the evaporator. This
releases the pressure of the bin switch
actuator arm allowing the switch to
open. Units placed under counters
and machines without curtains: An ice slide at the bottom of the evaporator is used on all under the counter
units and some modular units. The slideway swivels up and down and has a magnetic reed switch which
detects its position. When ice is sitting on the control, the slideway faces down indicating that ice is present
(and disconnecting the circuit from the reed switch). When the ice is removed, the slideway swivels up and the
connection is completed allowing the machine to begin producing ice again.
BIN CONTROL ADJUSTMENT
All Models (except those without curtains): Check the bin switch for proper adjustment by swinging the bottom
of the curtain away from the evaporator. Slowly bring the curtain towards the evaporator. The switch should
close when the bottom edge of the curtain is even with the outer edge of the water trough. Adjust the switch
by loosening the screws which hold the switch in place. Move the switch to the proper position and retighten
the screws. Recheck the adjustment. Under the counter models or those without curtains: There are no
adjustments needed for the bin (magnetic reed) switch.
Before Maintenance:
1. Ensure the electrical supply is 115 VAC, 60Hz, 15A and is properly grounded to protect maintenance
personnel.
ELECTRICAL SHOCK HAZARD
Disconnect electrical power before
beginning removal of parts
9
Operation

Maintenance