Installing & Cleaning Foam Sleeve Filter - EWT CS 3 Modo De Empleo

INSTALLING & CLEANING FOAM
1
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the outlet (Fig.1).
2. Remove power head and place in upside down position. Follow instructions to remove cloth filter (
Fig.2).
3. Carefully slide foam sleeve filter down over the filter cage making sure the whole cage is covered.
( Fig.3).
4. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam sleeve filter (Fig.4).
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water (Fig.5).
3. Allow filter to air dry before installing and using again.
SLEEVE FILTER
2 3
40
4
5