Installing And Cleaning Foam Sleeve FIlter - EWT CS 5 COMFORT Manual De Instrucciones

INSTALLING AND CLEANING FOAM
1
Installing Foam Sleeve Filter
1. Verify that the power cable is disconnected from the outlet (Fig.1).
2.
Remove power head and place in upside down position (Fig.2).
3. Carefully slide foam sleeve filter down over the filter cage making sure the whole cage is covered
( Fig. 3).
4. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
With the removed power head in the upside down position, carefully remove foam sleeve filter. (Fig.
1.
4)
Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water. (Fig. 5)
2.
Allow filter to air dry before installing and using again.
3.
SLEEVE FILTER
3
2
4
43
5