Direction For Use - Carmen NC4210 Manual De Instrucciones

- Unpack the unit and remove any stickers that can
prevent unit operation.
- Clean the unit body with a soft, slightly damp cloth and
then wipe dry.
- Rub the attachments (C-H) with medical alcohol to
disinfect them.
> DIRECTION FOR USE
- Insert one of the attachments (C-H) into the unit.
- If necessary, install the safety cover (B) on the unit body.
- Insert the batteries into the battery door (I).
- Switch the unit on by pressing the button (A) «0/1/2».
- When finished switch the unit off by pressing the button
(A) «0/1/2».
> ATTACHMENTS
We suggest some options for usage of the manicure/
pedicure attachments. Attention: Always switch the unit off
before installing and changing the attachments.
40 mm long sandpaper (C)
These attachments (one rough/one fine) are used for
smoothing the callused and hardened skin. Gently move the
attachment at the places where the hard skin or callus are
located.
12.5 mm long sandpaper (D)
These smaller attachments ( one rough/one fine) are for removal
of dead skin between the toes. Gently move the attachment at
the places where the hard skin or callus are located.
Sapphire grain cone (E)
This attachment is used for smoothing of the nail surface
and rough skin areas. Gently move the attachment along the
treated nail or skin surface.
Felt cone (F)
Smoothing and polishing the edge of the nail after filing as
well as for cleaning the nail surface. Always polish in circular
movements and do not allow the felt cone to rest in one
place, otherwise friction could cause heat to develop.
ENGLISH • 5