Parts - AccuBANKER AB-5000 MG/UV Manual De Usuario

Parts

Hopper
Place the notes to be counted in this compartment.
Auxiliary Hopper Plates
Aid to help position the notes correctly to be fed into the unit.
UV Lamp Cleaning Shaft
Built-in device that cleans the UV lamp.
Thickness Adjustment Screw
Used to make the counting operation smooth. The thickness adjustment is factory defaulted (for more
information, refer to the Operation section, point 7).
Stacker
The counted notes are stacked in this compartment.
Power Switch
Used to turn the power on or off.
Power Inlet
The supplied power cord should be connected to the power inlet first. The other end should be
connected to the AC power outlet.
Fluorescent Detection Sensitivity Adjustment Lever
The fluorescent detection sensitivity can be adjusted by sliding this lever up or down (for more
information refer to the Operation section, point 10 a).