Connecting The Camera - D-Link DCS-6517 Guia De Instalacion

Place the rubber seal between the right-angle bracket
and the ceiling to ensure a waterproof seal between
the ceiling and the bracket.
Attach the right-angle bracket to the ceiling using the
screws provided.
Attach the bracket cap to the bottom of the right-angle
bracket by rotating the cap counterclockwise to tighten
it into place.
Insert the screw into the base of the right-angle bracket
at the top of the bracket cap to secure the bracket cap
into place.
Thread an Ethernet cable and the power cable through
the pendant bracket.
Place the camera body onto the bracket cap and
attach the dome to the base of the camera using the
three long screws and the security screw.
Connection with a PoE Switch
ƒ Connect the Ethernet cable to your PoE switch
or injector. The Ethernet cable will provide
the camera with both power and a network
connection.
If you have the optional cable harness, you can also
use the following connection method:
General Connection Using 12 V DC Power Adapter
(not included)
ƒ Connect the Ethernet cable to your network.
ƒ Connect your power adapter to the camera's
power connector, then plug in the power
adapter.
8

Connecting the Camera

D-Link DCS-6517 Quick Installation Guide
7