Mounting The Camera - D-Link DCS-8300LH Guide D’iNstallation

MOUNTING THE CAMERA

Please refer to the steps below to assist you with mounting the camera. It is recommended that you
configure the camera before mounting.
1
2
3
4
5
6
4
Step 1:
Rotate the baseplate counter-clockwise and remove it.
Step 2:
Place the baseplate where you want to position the camera and
use a pencil to mark the holes. You can use the lower holes for a
removable installation, or the top holes for a fixed one. Make sure
that the arrow on the baseplate is pointing up.
Step 3:
Depending on the material of the wall or ceiling, use proper tools
to drill holes 25mm deep with a 6mm drill bit where you marked. If
the wall is made out of concrete, drill the holes first, then insert the
plastic anchors to support the screws.
Step 4:
Place the baseplate over the holes that are in the wall. Make sure to
align the baseplate holes with the holes in the wall. Use the supplied
screws to attach the baseplate to the surface of the wall.
Step 5:
Place the camera over the baseplate with the alignment nub pointing
left, then attach the camera by rotating it until the alignment nub
points up.
Step 6:
Adjust the angle and rotation of the camera as desired. You can also
rotate the camera on the baseplate approximately 45° to the right or
left.
DCS-8300LH