Pleasant Hearth WILMINGTON OFG321S Manual Del Usuario página 10

ASSEMBLY INSTRUCTIONS
4. Door Installation
Ensure the tank hole on the bottom plate (I) is in front
as pictured. Insert the spindle at the bottom of the
door (J) into the corresponding hole on the left side of
the bottom plate (I). Insert the top spindle of the door
(J) into the hole on the door bracket (H) as pictured.
Hold the door (J) in place as you attach the door
bracket (H) to the two front posts (E) with two M6X12
bolts (AA). Make sure to adjust the gap between the
door (J) and door bracket (H) to make it even when
tightening the bolts. Do not put door bracket (H) too
close to the door (J) to ensure that it can open easily.
Tighten with screwdriver (II).
Hardware Used
AA
Bolt M6 X 12
II
Phillips screwdriver
5. Side panel (G) installation
Attach three side panels (G) to the posts (E) with
twelve M6 X 12 bolts (AA). Tighten with screwdriver
(II). After installation, the base assembly will look like
figure 5.
Hardware Used
AA
Bolt M6 X 12
II
Phillips screwdriver
4
X 2
5
X 12
10
AA
J
Magnet
G
AA
H
I
E
E