Px-610U Quickstart Installation - Plextor PX-610U Manual De Instalación Y Del Usuario

NOTE: This applies to the Plextor retail box. Your drive may have
been shipped in a different box with other contents, depending on
whom you purchased the drive from and what they included inside
the box.
If your drive came pre-installed, some or all of the items above may
have been installed and may not be separately available. See the
Plextor web site for locations to purchase additional or replacement
accessories.

PX-610U QuickStart Installation

Here's an overview of what you'll do to connect the drive:
1. Connect the USB cable to the External DVD Drive
Plug in the USB cable into the USB port on the back of your
external DVD drive.
2. Connect the USB cable to your PC, Laptop, or Mobile Device
Locate an available USB port on your PC and plug the other end of
the USB cable in that port.
Note: High Speed USB (2.0) ports provide high-speed data transfer
rates. You can connect the external DVD drive to a USB (1.1) port, but
this is not recommended because it will significantly lower the external
DVD drive's read speeds. If you are unsure about which ports are
available on your PC, check your PC manual or Windows device
manager.
Troubleshooting tip: You can verify that your external DVD drive has
power by pressing the EJECT button on the front of the external DVD
drive to open and close the tray. If the tray does not open, ensure that
the cables are plugged in properly and securely.
3. Install the software
Note: Please ensure your external DVD drive is detected and properly
installed by the operating system before installing application software.
For further troubleshooting assistance, please refer to your PC's and
Microsoft Windows help, under the "help support" section, in "adding
new devices".
Insert the Software Installation Disc into your external DVD drive. Click on
Install Suite. Follow the on-screen instructions.
Section 4. Using Your PX-610U
PX-610U Installation and Users Manual
11