Using
the
Wall.Mounted
To Open
the
Door
Manually
Door
Control
THE PREMIUM CONTROL CONSOLE
Press the lighted push button
to open or close the door.
Press again to reverse the
door during the closing cycle
or to stop the door while it's
opening.
Light feature
I
ILIGHTBD
PUSH BUTTON
LIGHT
BUTTON
LOCK
BUTTON
Press the Light button to turn the opener light on or
off. It wilt not control the opener light when the door is
in motion. If you turn it on and then activate the
opener, the light will remain on for 4-1/2 minutes.
Press again to turn it off sooner.
Lock feature
Designed to prevent operation of the door from hand-
held remote controls. However, the door will open
and close from the Door Control, the Outdoor Key
Switch and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2
seconds. The push button light will flash as long as
the Lock feature is on.
To turn off, press and hold the Lock button again for
2 seconds. The push button light will stop flashing.
The Lock feature wilt also turn off whenever the SRT
(Smart ReceivedTransmitter)
button on the motor unit
panel is activated.
Additional feature when used with the 3-function
hand-held remote
To control the opener lights:
In addition to operating the door, you
___
may program the remote to operate
the lights.
1. With the door closed, press and hold a small
remote button that you want to control the light.
2. Press and hold the Light button on the Premium
Control Console.
3. While holding the Light button, press and hold the
Lock button on the door control.
4. After the opener light flashes, release all buttons.
• To prevent possible SERIOUSINJURYor DEATHfrom
a falling garage door:
- If possible, use emergency release handle to
disengagetrolley ONLYwhen garage door is
CLOSED.Weak or broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly.
- NEVERuse emergency releasehandle unless garage
doorway is clear of persons and obstructions.
• NEVERuse handle to pull door open or closed. If rope
knot becomes untied, you could fall.
DISCONNECT THE TROLLEY:
The door should be fully closed
Trolley
if possible. Pull down on the
-
i
emergency release handle (so
that the trolley release arm
snaps into a vertical position)
Trolley
._J
and lift the door manually. The
Release a rn
lockout feature prevents the
(InManual
Disconnect
trolley from reconnecting
Position)
automatically, and the door can
be raised and lowered manually
as often as necessary.
Lockout
)osition
(Manual disconnect)
TO RE-CONNECT
THE TROLLEY:
Pull the emergency release
Trolley
handle toward the opener at
_I_IY
a 45 ° degree angle so that
the trolley release arm is
horizontal. The trolley wilt
Trolley
reconnect on the next UP or
Release
DOWN operation, either
Emergency __
Release Handlee)_,_
manually or by using the
(Pullat45Oang
I _._._,
"
#
door control or remote.
To reconnect
32