Technical Description (Component And Interfaces) - Sirona inLab MC X5 Instrucciones De Uso

3 General information on the device
3.3 Technical description (component and interfaces)
12
3.3

Technical description (component and interfaces)

The suction devices are intended for operation on the inLab MC X5 or on
the CEREC MC/MC X/MC XL Premium Package milling units. The
suction system is equipped with a special filter bag and a HEPA micro
filter of filter category H12, which filters fine dust up to 99.5% and is
classified as fine dust category M.
A Socket for suction tube
B Control panel
C Maintenance flap
D Socket for interface cable
Check the device for any transport damage immediately after unpacking.
If there is transport damage, raise this with your supplier immediately.
Operating Instructions Suction devices for inLab MC X5 and
E On/Off switch
F Socket for power cable
G Suction power control
H Device safety switch
Sirona Dental Systems GmbH
64 98 609 D3608
D3608.201.02.02.02 11.2015