Iso Din Head Unit Provision - Metra 99-8203 Instrucciones De Instalación

ISO DIN head unit provision

1. Align the holes in the ISO brackets
mount the brackets to the radio with the
screws supplied with the unit.
2 Slide the radio/bracket assembly into
the radio opening until the side clips
engage and snap the trim plate over the
unit. (Figure A)
Note: To remove the mounted radio,
unclip and remove the ISO trim plate.
Using a small flat-blade screwdriver,
disengage the side clips securing the
ISO brackets to the radio housing.
3. Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
4. Reassemble dash in reverse order
of disassembly.
Kit Assembly 99-8203
6
(Figure A)
(Figure B)