Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
KIT FEATURES
• DIN radio provision
KIT COMPONENTS
• A) Radio housing • B) HVAC display harness (not shown)
A
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • TYTO-01 • 70-1761
Antenna Adapter: • Not required
TOOLS REQUIRED
• Phillips screwdriver • Panel removal tool • Socket Wrench
METRA. The World's best kits.
Installation instructions for part 99-8215
Toyota Avalon
2005-2010
99-8215
™
metraonline.com
Table of Contents
Dash Disassembly ................................................. 2
Kit Assembly
HVAC harness wiring ........................................... 3
DIN radio provision .............................................. 3
CAUTION!
Metra recommends disconnecting the negative bat-
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con-
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
Publicidad
Manuales relacionados para Metra 99-8215
Resumen de contenidos para Metra 99-8215
- Página 1 Installation instructions for part 99-8215 Toyota Avalon Table of Contents 2005-2010 Dash Disassembly ..........2 99-8215 Kit Assembly HVAC harness wiring ........... 3 DIN radio provision ..........3 KIT FEATURES • DIN radio provision KIT COMPONENTS • A) Radio housing • B) HVAC display harness (not shown)
-
Página 2: Dash Disassembly
99-8215 Dash Disassembly 1. Unclip and remove small trim 3. Unclip and remove entire panel piece from left side of panel above surrounding radio including A/C steering wheel. (Figure A) controls. (Figure C) 2. Unclip and remove panel above 4. Remove (4) 10 MM bolts securing steering wheel. -
Página 3: Kit Assembly
4. Locate the factory wiring harness and antenna plug in the dash and (Figure A) make all necessary connections to the radio. Metra recommends using the proper mating adapters from Metra and/or AXXESS. 5. Mount the new radio assembly into the dash and reassemble the dash in reverse order of disassembly. -
Página 4: Important
Installation instructions for part 99-8215 IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. -
Página 5: Características
Sería mejor retirar la llave de la ignición y esperar unos HERRAMIENTAS REQUERIDAS cuantos segundos antes de quitar el radio de fábrica. • Destornillador Phillips • Herramienta para quitar paneles • Llave de tubo METRA. The World’s best kits. metraonline.com ™ © COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION... - Página 6 99-8215 Desmontaje Dash 1. Desenganche y quite la pequeña 3. Desenganche y quite todo el panel pieza de moldura del lado que rodea el radio, incluyendo los izquierdo del panel sobre el controles del aire acondicionado. volante. (Figura A) (Figura C) 2.
-
Página 7: Ensamble Del Kit
4. Localice el arnés de cableado de fábrica y el conector de la antena en el tablero y haga todas las conexiones necesarias al radio. Metra recomienda que use adaptadores adecuados de acoplamiento de Metra y/o de AXXESS. 5. Monte el ensamble del radio nuevo en el tablero y vuelva a armar el tablero al revés de como lo... -
Página 8: Importante
800-354-6782 para obtener más información y avance hacia un futuro mejor. Metra recomienda técnicos con certificación del Programa de Certificación en Electrónica Móvil (Mobile Electronics Certification Program, MECP). METRA. The World’s best kits. metraonline.com ™ © COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION...