Publicidad
Idiomas disponibles
Idiomas disponibles
General installation
1.
Connect the exhaust duct to the outside exhaust
system (see pages 5 through 7). Use of a 4" (102
mm) clamp (item A) is recommended to connect
the dryer to the exhaust vent system. Use metal
foil tape to seal all other joints.
2.
Carefully slide the dryer to its fi nal position.
Adjust one or more of the legs until the dryer is
resting solidly on all four legs. Place a level on
top of the dryer. The dryer MUST be level and
resting solidly on all four legs. Rock alternating
corners to check for stability. Remove and
discard door tape.
IMPORTANT
Be sure the power is off at a circuit breaker/fuse
box before plugging the power cord into an outlet.
3.
Plug the power cord into a grounded outlet.
4.
Turn on the power at the circuit breaker/fuse
box.
5.
Read the
Use & Care Guide provided with
the dryer. It contains valuable and helpful
information that will save you time and money.
6.
See the next page about performing a brief,
helpful "Installation Cycle" for your new dryer.
7.
If you have any questions during initial
operation, please review the "Avoid Service
Checklist" in your Use & Care Guide before
calling for service.
8.
Place these instructions in a location near the
dryer for future reference.
NOTE
A wiring diagram and technical data sheet are
located inside the dryer console.
Grounding type
Grounding type
wa
wall receptacl
ll receptacle
Do not, under
Do not,
an any cir
cut, remo
cut,
or bypass th
or b
gr grounding pr
Po Power cord with
wer cord with
3-prong gr grounded plug
3-prong
ounded plug
Installation Instructions
under
y circumstances,
cumstances,
remove ve,
ypass the
ounding prong.
ong.
A
17
Publicidad
