Peavey Supreme XL Manual De Instrucciones página 8

( ( 2 2 6 6 ) ) P P O O W W E E R R
This three-position switch selects the power output level of the power amplifier. This switch works like
the T. Dynamics
provides for a more pronounced tube power compression simulation at lower settings.
( ( 2 2 7 7 ) ) S S P P E E A A K K E E R R O O U U T T P P U U T T S S
These parallel 1/4" mono (TS) jacks are provided for the connection of speaker enclosure(s). Minimum
speaker impedance is 8 Ohms. Although you can daisy-chain enclosures‚ it is preferable to use both
1/4" jacks thereby maintaining proper gain structure as well as ensuring optimum performance.
( ( 2 2 8 8 ) ) G G R R O O U U N N D D P P O O L L A A R R I I T T Y Y S S W W I I T T C C H H
This three-position rocker switch should normally be placed in the center (0) position. If hum or noise
is noticed coming from the speaker enclosure(s), the switch may be placed in the "+" or "-" position to
minimize hum and noise. If changing the polarity does not alleviate the problem, consult your
authorized Peavey dealer, the Peavey factory, or a qualified service technician.
( ( 2 2 9 9 ) ) I I E E C C M M A A I I N N S S C C O O N N N N E E C C T T O O R R
This is a standard IEC power connector. An AC mains cord having the appropriate AC plug and ratings
for the intended operating voltage is included in the carton. The mains cord should be connected to
the amplifier before connecting to a suitable AC outlet.
U U . . S S . . D D O O M M E E S S T T I I C C A A C C M M A A I I N N S S C C O O R R D D
The mains cord supplied with the unit is a heavy-duty, three-conductor type with a conventional 120
VAC plug with ground pin. If the outlet used does not have a ground pin, a suitable grounding adapter
should be used, and the third wire should be grounded properly.
C C a a u u t t i i o o n n : : Never break off the ground pin on any equipment. It is provided for your safety.
F F O O O O T T S S W W I I T T C C H H
30
( ( 3 3 0 0 ) ) S S e e l l e e c c t t
This rockin' 2-button stereo footswitch is included with every Supreme
channels and engage or defeat the effects loop. This Select button allows for easy‚ hands-free selection of
either the Lead or Rhythm channel. The 14-foot cable gives you plenty of room to maneuver. Connect the 1/4"
jack to the Remote Switch (19) and you're ready to stomp. Please make sure to connect this footswitch with the
Power Off.
( ( 3 3 1 1 ) ) E E f f f f e e c c t t s s
This one is easy. Stomp on the Effects button and engage or disengage your connected effects devices.
® control found on other Peavey amplifiers (visit www.peavey.com for more info)which
8
™ XL. Only what's called for—change
31