Toto TBP01301 Manual De Instalación página 13

EN
Mount the faucet main body
7 In order to prevent reversed piping, pay attention to the direction of the faucet
main body when mounting the faucet main body onto the tub filler rough.
8 Adjust the direction of the spout in relation to the bathtub and anchor the
faucet main body using the included bolts. Confirm that the faucet main body
is vertical.
Check the faucet main body for looseness and make sure that water does
not pass through the product or leak from the connections when the handle is
closed.
Caulking
9
Apply silicone caulk to waterproof the clearance between the plaster guard
and the floor, and lower the plaster guard down to the finished floor surface.
Mounting the hand shower and hose
10 Make sure that the gasket is mounted adequetly, then mount the shower hose
and the hand shower. This completes product installation.
Testing the water supply connections
11
Turn on the water supply and confirm that water comes out from the spout
and shower.
Check the around the hose connections and clearances for any water
leakage.
Cleaning the spout opening
12 After testing the water supply connections, clean the spout opening.
If the spout opening clogs, the flow rate may decrease or the temperature
control may not work effectively. This may cause the product to not function
as expected.
Please explain to the customer that the spout opening must be cleaned
periodically.
Remove the spout opening by inserting a flathead screwdriver or
similar tool into the notch.
Avoid damaging the faucet main body during removal.
Specifications
Operating pressure range
Recommended Operating pressure
Test pressure
Hot water temperature
Recommended hot water temperature :
Flowrate under 0.3 MPa
13
: Max 1.0 MPa
: Min 0.05 MPa
: 0.1 - 0.5 MPa
: 1.6 MPa
: Max. 80 °C
60 °C
: approx 18 l/min