Electrical Equipment - Sima Bali 700 MKNO Manual De Instrucciones Original

5. ELECTRICAL EQUIPMENT

The electrical equipment of the BALI MKNO cutting tables manufactured by SIMA, S.A. has an IP54 protection
degree. The power supply on this machine has a low minimal tension coil to avoid any unexpected starting-up of the
machine. When there is a power cut or a fall of tension that causes the machine to stop, and once the normal power
conditions have been re-established, the motor does not start until the green button is pressed.
WARNING: The three-phase BALI MKNO models leave the factory prepared to work at 400V.
WARNING: When necessary to use a
tension at 230V, we need to swap the
plates in the motor terminals box, as
figure:
WARNING:
The
minimum section on the table as shown
WARNING: The extension cable for the machine should have a minimum thickness as stated on
the below table.
extension cable used to feed the machine needs to have a
7
ENGLISH
three-phase power
positions of the bridge
indicated in the following