Measurement Menu - CARLO GAVAZZI EM111 Instrucciones De Instalacion Y Uso

Measurement menu

00 01 02
Fig. 13
NOTE *: only displayed if full display mode is set (Mode = Full).
To navigate in the menu, see "Commands" on page 3.
Page
Home page. Total imported active energy. If easy connection is on (Measure = A), it indicates total active
00
energy without considering the direction.
Only if imported and exported energy are measured separately (Measure = b). Total exported active
01
energy.
Active power
02
03 Voltage
Current
04
Power factor (L = inductive, C = capacitive)
05
06 Frequency
Home page. Total imported reactive energy. If easy connection is on (Measure = A), it indicates total
07
reactive energy without considering the direction.
Only if imported and exported energy are measured separately (Measure = b). Total exported reactive
08
energy.
Reactive power
09
Requested average power (d = demand) calculated for the set interval. The value remains the same for
10
the entire interval. It is = 0 during the first start up interval.
Maximum requested power (Pd = Peak demand) reached since last reset
11
Active energy imported with tariff 1. tar 1 appears after 5 s and remains displayed for 2 s. Displayed if tariff
12
management is on (Tariff = on).
Active energy imported with tariff 2. tar 2 appears after 5 s and remains displayed for 2 s. Displayed if tariff
13
management is on (Tariff = on).
Measurement faults
If the measured signal exceeds the admitted analyzer limits, a specific message appears:
EEE blinking: the measured value is out of limits
l
EEE on: the measurement depends on a value that is out of limits
l
NOTE: active and reactive energy measurements are displayed but do not change.
8021438 | EM111
*
03 04 05 06
* * * *
07 08 09
Description
* *
10 11 12
©2014 | CARLO GAVAZZI Controls SpA| 5
13