How To Change Frequencies; Care And Maintenance - Carson CV-10 Manual De Usuario

i. How to Change Frequencies
Transmitter
crystal
j. Care and Maintenance
Failure to follow break-in procedure and/or damage caused by
improper tuning will void your engine warranty.
There are two ways to "temp" your engine. One, purchase a
temperature gauge. The second cheaper, but less accurate method
is the "Spit Test". Wipe a little bit of saliva on the engine head and it
should burn off in 3 - 4 seconds (the boiling point of water normally is
100 °C). If it evaporates immediately, chances are the engine is running
too hot.
The engine will run best and be easier to restart if run around
100-125 °C. Depending on your weather conditions, air density, and
humidity, your carburettor settings will be changing wherever you
decide to run. Making adjustments in small increments is the best way
to make sure your engine lasts a long time. Overheating is caused by
running the engine too lean, or too much stress on the engine created
by the environment. Extreme overheating will result in internal failure
of engine parts.
There are many online resources that will help you with engine tuning.
3.5 ccm engines are designed to last a long time, and with proper
maintance and tuning, you can drive the model for hours at a time.
After Use
When you have finished running your car, there are two options to
shut the engine down. The first method is to place your thumb over
the exhaust outlet (Wear gloves). Make sure your engine is normal idle,
preferable with the brake activated.
The second method is to pinch off the air supply from the engine.
Do not pinch the fuel line, as this may cause the engine to overheat!
Try and let all the remaining fuel run through the engine, emptying
the fuel tank. The engine will idle high while the tank is emptied, so
the above two steps may not be necessary.
(Only with the 27/40 MHz version)
40
FM
Transmitter
A rapid change of frequencies is possible simply by unplugging an
interchangeable plug in crystal on the back of the transmitter and then
plugging in another one of a different frequency.
Crystals for both the transmitter and receiver must be matched with
each other.
Make sure that the crystal is fully inserted in the transmitter and
receiver, not partially.
Receiver crystal
Picture 9
Then apply after-run oil through the carburettor, and pull the pull-start
a few times to get it through the engine. This is recommended if you
plan on storing the car for more than a day. Methanol evaporates in
water and can cause internal corrosion to engine parts. It is always a
good idea to check all the screws, nuts, and bolts before and after each
period of racing.
Picture 10
Keeping the car clean will also make it more fun to work on. This can
be achieved with a large heavy-duty paintbrush, or compressed air.
Always test the transmitter and receiver batteries before starting the
engine.
Racer Tip:
Wear gloves when working on your hot car!
CV-10 NEW GENERATION
Receiver
Plug in an interchangeable
crystal into the receiver for a
rapid change of frequencies.
23
GB