-
See chapter 'Preparing for use', section 'Tanning advice' for information
about sun exposure and artificial tanning.
Cleaning and maintenance
To ensure optimal results and a long life for the appliance, clean the
appliance before and after each use and, if necessary, also during the
treatment. The appliance loses its effectiveness if you do not clean it
properly.
Never clean the appliance or any of its parts under the tap or in the
dishwasher.
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the appliance.
Never scratch the light exit window or the metallic frame inside the
body attachment.
Note: Stop using the appliance when it is no longer possible to clean the light
exit window or the body attachment.
1
Switch off the appliance, unplug it and let it cool down.
Note: The light exit window becomes hot during use. Make sure it has cooled
down before you clean it.
2
To remove the body attachment, grab the projections at the top and
bottom and pull gently.
3
If necessary, clean the outside of the appliance with the soft cleaning
cloth supplied with the appliance.
4
Moisten the soft cloth supplied with the appliance with a few drops
of water and use it to clean the following parts:
-
the light exit window
-
the outside surface of the body attachment
-
the metallic frame inside the body attachment
Make sure that the electronic contacts do not get wet.
Note: If water does not clean effectively, use a few drops of high-percentage
alcohol to clean the parts mentioned above.
Note: Make sure you clean the appliance before and after each use and,
if necessary, also during the treatment according to the instructions in this
section.
Storage
1
Switch off the appliance, unplug it and let it cool down.
2
Clean the appliance before you store it.
3
Store the appliance in the pouch supplied at a temperature between
-20°C and +70°C.
Tip: We advise you to store the quick start guide in the pouch for future
reference.
ENGLISH
19