Dmx Linking - Chauvet STRIKE 882 Guía De Referencia Rápida

STRIKE™ 882 QRG
AC Power
Power Linking
AC Plug
Replacing the
Fuse

DMX Linking

DMX Connection
Master/Slave
Connection
This product has an auto-ranging power supply that can work with an input
voltage range of 100–240 VAC, 50/60 Hz.
To eliminate unnecessary wear and improve its lifespan, during
periods of non-use completely disconnect the product from power via
breaker or by unplugging it.
You can link up to 3 STRIKE™ 882 products at 120 V, 5 products at 208 V,
or 6 products at 230 V. Never exceed this number. Power linking cords can be
purchased separately.
Connection
AC Live
AC Neutral
AC Ground
1.
Disconnect this product from power.
2.
Using a flat-head screwdriver, unscrew the fuse holder cap from the
housing.
3.
Remove blown fuse and replace with a good fuse of the same type
and rating.
4. Screw the fuse holder cap back in place and reconnect power.
The STRIKE™ 882 will work with a DMX controller using a regular DMX
serial connection.
www.chauvetprofessional.com.
The STRIKE™ 882 uses a regular DMX data connection for its DMX
personalities: 1 Ch, 5 Ch, 6 Ch, and 10 Ch. See the User Manual to connect
and configure for DMX operation.
The STRIKE™ 882 uses the DMX data connection for its Master/Slave
mode. See the User Manual to connect and configure for master/slave
operation.
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
A DMX Primer
3
Screw Color
Brown Yellow/Brass
Blue
Green
is available
EN
Silver
from