Fujitsu Ten Eclipse CD3000 Manual Del Propietário página 37

SVC (Source Volume
Control)
LOUD
Setting examples:
The volume for the initial FM mode (default value: 40) is used as a reference for storing the differences
in volume that have been set for each audio mode.
Audio mode
Default value
(Volume level)
SVC setting
(Volume level)
When volume level in FM
mode is adjusted from 40
to 45
When volume level in CD
mode is adjusted from 35
to 60
When volume level in AM
mode is adjusted from 80
to 20
*:The volume levels can be set to a maximum of 80 and a minimum of 0. If you try to go past the
maximum or minimum volume level, the level will not change. For the CD changer, SVC
adjusts the volume using the setting value for the CD player.
The volume difference can be set within a range of -10 to +20.
ATTENTION
If the battery terminals have been disconnected because of vehicle maintenance, the SVC settings
will return to their default values. If this happens, you will need to make the settings again.
Adjusts different volume levels for each
audio mode. When SVC is set, the
volume level can change as shown in the
example settings in the table on the this
page.
The loudness control may be turned on to
emphasize low and high frequencies at
low volume levels.
Loudness compensates for the apparent
weakness of low and high frequencies at
low volume by boosting the bass and
treble levels.
FM
Reference
(40)
SVC setting
Reference
(40)
+15 (55)
55 ➔ 60
45
45 ➔ 70 60 ➔ 80*
70 ➔ 5
How to operate the AUDIO CONTROL
Decreases the SVC
setting level.
Turn the loudness control ON/OFF.
AM CD
0 0
(40) (40)
SVC setting
value value
-10 (30)
30 ➔ 35
60
60 ➔ 0*
20
Increases the SVC
setting level.
37
IX