Before First Use - Breville Ikon Cordfree Manual De Instrucciones

Operating your Breville Ikon Cordfree Kettle

Before first use

Remove any promotional material attached to your
kettle. It is recommended that before the first use the
kettle is filled to the maximum level, boiled and
water discarded. Your kettle will only operate when
positioned on the power base with the On/Off switch
in the On position. The kettle will automatically
switch off once the water has boiled.
Operation of your kettle
1. To fill the kettle, remove it from the power
base and open the lid by pressing the lid release
button. Fill with the desired amount of water.
Always fill the kettle between the minimum and
maximum marks on the water window. Too little
water will result in the kettle switching off before
the water has boiled.
2. Ensure that the lid is locked firmly into place.
Place the kettle firmly onto the power base.
Plug the power cord into 110V power outlet.
3. Press the On/Off switch to the 'On' position.
The power 'On' light and the water guage
will illuminate.
Always fill the kettle between the minimum
(Min) and the maximum (Max) marks on the
exterior of the kettle. Too little water will result
in the kettle switching "Off" before the water
has boiled. Filling above the maximum mark on
the exterior of the kettle may result in boiling
water splashing from the kettle.
THIS APPLIANCE IS DESIGNED FOR THE BOILING OF DRINKING QUALITY WATER ONLY, NEVER
USE IT TO HEAT OR BOIL ANY OTHER LIQUIDS OR FOODSTUFFS. THE LID SHOULD ALWAYS BE
FIRMLY IN PLACE AND LOCKED CLOSED BEFORE USE.
This kettle must only be used with the power
base supplied. Use caution when pouring water
from your kettle, as boiling water will scald. Do
not pour the water too quickly.
The kettle will automatically switch 'Off' once the
water has boiled. Lift the kettle from the power base
and pour the water. Take care to hold the kettle level,
especially when filled to the maximum level. To
re-boil it may be necessary to wait for a few seconds
to allow the control to reset.
The kettle may be stored on its power base when not
in use. Remove the power cord from the power outlet.
Safety boil dry protection
The kettle is fitted with a safety device, which
protects against overheating should the appliance be
operated with insufficient water. If this occurs the
kettle will stop heating. Switch 'Off' at the power
point and allow kettle to cool before refilling. The
safety device will automatically reset when the kettle
has cooled down.
For additional safety your kettle is fitted with an
additional thermal cut out. In the event of
overheating, the kettle will automatically shut down
to prevent further damage. Should this occur, take
your kettle to an authorised Breville Service Center.
Note
Note
7