Frequently Asked Questions - Marmitek TV ANYWHERE Modo De Empleo

6. FREQUENTLY ASKED QUESTIONS

The system does not work properly
Attention: The power adapters for the transmitter and receiver are different. You need
to connect the small power adapter to the receiver. The large power adapter needs to be
connected to the transmitter.
Poor picture quality on all TV channels
1. Disturbances in the signal can sometimes affect the transmission quality. Move the TV
Anywhere transmitter or receiver a few centimeters to solve the problem.
2. Change the channel settings (A .. D) for both the transmitter and the receiver. The channel
setting on the transmitter must match the setting on the receiver (e.g. both set to B).
Poor picture quality on some of the TV channels
1. Check the antenna connection of the TV Anywhere transmitter. You can check the signal on
the transmitter side by directly connecting a TV to the antenna connection. It is especially
important to check your antenna system, as high frequency channels contain more noise
that lower frequency channels.
2. If the TV channel found is not tuned properly, use the FINE TUNE+ and FINE TUNE- buttons
to fine tune the TV channel. Press COPY followed by PASTE to store the new settings.
The infrared extender does not work
1. Is the infrared extension cable connected to the TV Anywhere transmitter? Are the infrared
eyes attached to your equipment at the right position? Try to experiment with their location
if you are not convinced of the right position on your device.
2. If you are using wireless headphones, wireless speakers or other equipment using
433.92MHz transmission, this could affect the range of the infrared extender function
dramatically. Switch these devices off to improve the range.
The remote won't work with the TV Anywhere
1. The code for the remote control does not match the code set up for the TV Anywhere
system.
2. To operate the TV Anywhere with the remote provided, you need to point it at the TV
Anywhere receiver.
3. To operate the TV Anywhere with the remote provided, it has to be set to TV Anywhere
mode. To set it to the TV Anywhere mode, press the [CBL] button.
4. Using a wireless baby monitor, wireless headphones or wireless speakers that use the
same frequency as the infrared extender of your TV Anywhere (433 MHz), will significantly
decrease the range.
5. Read paragraph 5 on how to set the handset code
My TV Anywhere cannot find any channels
1. You have chosen the wrong TV system. Read paragraph 3.
2. Check your antenna connection.
TV Anywhere™ 11