Instalation; Start Up - Sagola 6110 Manual De Instrucciones Y Lista De Repuestos

INCORRECT INSTALLATION OF THE MACHINE
MAY CAUSE DAMAGE TO PEOPLE, ANIMALS
OR OBJECTS. THE MANUFACTURER CANNOT
BE CONSIDERED RESPONSIBLE FOR THESE
DAMAGES.
6.1 Transport and discharge
The remover is delivered packaged. It must be
transported and stored according to the
indications on the packaging.
Due to the low weight of the remover can be
moved by two people without using other
means.
6.2 Arrangement of the lighting system
The Client must make sure that there is suitable
lighting for the surroundings and that the
lighting conforms to the regulations in force. In
particular, the Client must arrange the positio-
ning of lighting that illuminates all the working
area.
6.3 Arrangement of the pneumatic system
The Client must arrange a line of filtered
compressed air supplied by a compressor that
is suitable for the consumption required.
Do not use compressed air that contains
chemical products, synthetic oil with organic
solvents, salts or corrosive gases as they can
cause damage or malfunctioning. The line of
compressed air must arrive up to the supply
points of the machine. If the compressed air
contains a large amount of moisture, it may
cause malfunctioning in the valves and in the
pneumatic components. Install a moisture
separator downstream from the compressor to
avoid this.

7.1. Start up

BEFORE CARRYING OUT ANY OPERA-
TION, RELEASE THE PRESSURE ACCOR-
DING TO THE INSTRUCTIONS PROVIDED
IN PARAGRAPH 7.2
- Connect the pressure pot to the compressor.
Turn the regulator wheels (1) anticlockwise.
Close the product outlet valves (2).
- Once the equipment has been assembled,
check that the hose is connected correctly.

6. INSTALATION

6.4 Classification according to the ATEX
directive
The machine conforms to the essential requisi-
tes of the EU Directive 94/9/EC, better known as
ATEX ("Explosive atmospheres"). It is classified
as group II category 3 letter G system.
The assessment procedures of conformity,
carried out by an internal factory check, allow
the installation of the machine in surroundings
where there may be potentially explosive
atmospheres due to the presence of gas, fumes
or mist.
(*) 6.5 Equipment assembly
1. Air inlet to pressure pot.
2. Regulador de presión calderín.
3. Discharge valve.
7. START UP
2
- 16 -
II 2G T60
3
1
o
CX
2
1