Tabla de contenido
Publicidad
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must follow
the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves established by the Federal
Communications Commission (USA). These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The
highest SAR value reported under this standard during product certification for use when properly worn on the body.
ISED Compliance Notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1)This device may not
cause interference.(2)This device must accept any interference, including interference that may cause undesired operation of
the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes :(1)L'appareil ne doit pas produire de brouillage; (2)L'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user must follow
the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.The portable device is designed to meet the requirements for exposure to
radio waves established by the ISED.
Cet équipement est conforme aux limites d'exposition aux rayonnements ISED établies pour un environnement non contrôlé.
L'utilisateur final doit suivre les instructions spécifiques pour satisfaire les normes. Cet émetteur ne doit pas être co-implanté
ou fonctionner en conjonction avec toute autre antenne ou transmetteur. Le dispositif portatif est conçu pour répondre aux
exigences d'exposition aux ondes radio établie par le développement énergétique DURABLE.
These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this
standard during product certification for use when properly worn on the body.
Ces exigences un SAR limite de 1,6 W/kg en moyenne pour un gramme de tissu. La valeur SAR la plus élevée signalée en
vertu de cette norme lors de la certification de produit à utiliser lorsqu'il est correctement porté sur le corps.
部件名称
线路板
外壳
金属部件（铜合金）
内部线材
其他配件
本表格依据 SJ/T 11364 的规定编制。
○：表示该有害物质在该部件所有均质材料中的含量均在 GB/T 26572 规定的限量要求以下。
×：表示该有害物质至少在该部件的某一均质材料中的含量超出 GB/T 26572 规定的限量要求。（产品符合欧盟
ROHS 指令环保要求）
KCC Compliance Notice
"해당무선설비는 운용 중 전파혼신 가능성이 있으므로 인명안전과 관련된 서비스는 할 수 없습니다 ."
"해당 무선설비는 운용 중 전파혼신 가능성이 있음"
NCC Compliance Notice
取得審驗證明之低功率射頻器材，非經核准，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及
功能。低功率射頻器材之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時
方得繼續使用。前述合法通信，指依電信管理法規定作業之無線電通信。低功率射頻器材須忍受合法通信或工業、科學及
醫療用電波輻射性電機設備之干擾。
注意：
應避免影響附近雷達系統之操作。
高增益指向性天線只得應用於固定式點對點系統。
單元
Unit
鉛
Lead (Pb)
線路板
－
外殼
○
排針
○
其他
－
備 考 1.〝超出 0.1 wt % 〞 及〝超出 0.01 wt % 〞係 指限用物 質 之百分比含量超出百分比含量基 準 值。
備 考 2.〝○ 〞係 指 該項 限用物 質 之百分比含量未超出百分比含量基 準 值。
備 考 3.〝－ 〞係 指 該項 限用物 質 為排除 項 目。
EU Compliance Statement: SZ DJI TECHNOLOGY CO., LTD. hereby declares that this device is in compliance with the
essential requirements and other relevant provisions of the Directive 2014/53/EU.
A copy of the EU Declaration of Conformity is available online at www.dji.com/euro-compliance
EU contact address: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany
GB Compliance Statement : SZ DJI TECHNOLOGY CO . LTD. hereby declares that this device is in compliance with the
essential requirements and other relevant provisions of Radio Equipment Regulations 2017.
38
铅 (Pb)
汞 (Hg)
×
○
×
○
×
○
×
○
×
○
設備名稱：DJI Motion Controller，型號（型式）：FC7BMC
鎘
汞
Cadmium
Mercury (Hg)
(Cd)
○
○
○
○
○
○
○
○
有害物质
镉 (Cd)
六价铬 (Cr
+6
)
○
○
○
○
○
○
○
○
○
○
限用物質及其化學符號
六價鉻 Hexavalent
chromium (Cr
+6
)
○
○
○
○
多溴联苯 (PBB)
○
○
○
○
○
多溴聯苯 Polybrominated
biphenyls (PBB)
○
○
○
○
多溴二苯醚 (PBDE)
○
○
○
○
○
多溴二苯醚
Polybrominated
diphenyl ethers (PBDE)
○
○
○
○
Publicidad
Tabla de contenido
